I get no VPN connection and nothing in debug screen. With this config I can successfully connect and ping 192.168.20.1 (router) and 192.168.20.10 (dns server).īut when I replace the last line (ip local pool VPNpool) with the following: group easyvpnremotegroupname key xxx mode network-extension peer 193.128.190. It will create a VPN using a virtual TUN network interface (for routing), will listen for client connections on UDP port 1194 (OpenVPN's official port number), and distribute virtual addresses to connecting clients from the 10.8.0.0/24 subnet. Permit ip 192.168.20.0 0.0.0.255 192.168.20.0 0.0.0.255 The sample server configuration file is an ideal starting point for an OpenVPN server configuration. Tunnel protection ipsec profile easy_vpn_profile Step 1: Under the Configuration tab of Router 2 (Client), click EasyLink VPN > Outbound EasyLink VPN. Codes: C connected, S static, I IGRP, R RIP. On the client side, the account credentials and the Primary Server IP Address or the WAN IP of Router 1 (Server) are required in the Outbound EasyLink VPN tab. There are other VPN solutions available, but OpenVPN provides an easy to use interface for configuration of the Access Server, in addition to an easy to use OpenVPN Connect client application to get your devices connected.
#Easyvpn network extension plus config example plus#
PAT not used Network extension plus mode Additional capability of being. OpenVPN is a VPN (Virtual Private Network) solution that helps you secure your data communications. For example, destination network 192.168.30.0 is learnt via EIGRP and can be reached via 10.10.10.2 from the Serial0/0/0 interface. SNRS v2.04-1 Secured Connectivity Configuring Cisco Easy VPN Remote Access.
Interface Virtual-Template 20 type tunnel The routing table of Router R1 shows three networks learnt via EIGRP (denoted as D) and also two directly connected routes denoted as C. Looks like I miss something.Ĭrypto isakmp client configuration group VPN-GROUPĬrypto isakmp profile easy_vpn_ike_profileĬrypto ipsec transform-set ESP-3DES-SHA esp-3des esp-sha-hmac Today I found what appears to be the solution and its related to the link and routing between the two office main. All but one of the remote VPN routers are 871 or 871w. May 18 12:25:45.411: %LINK-3-UPDOWN: Interface Virtual-Access2, changed state to downĪnd then I got on the client: No private IP address was assigned by the peer and the session disconnected. But when the ezvpn client mode was changed to 'network-extension' or 'network-plus' the remote hosts could only access the internet and nothing on the broader corporate LAN/WAN.
May 18 12:25:44.355: %IP_VFR-7-FEATURE_DISABLE_IN: VFR(in) is manually disabled through CLI VFR support for features that have internally enabled, will be made available only when VFR is enabled manually on interface Virtual-Access2 May 18 12:25:44.351: %LINEPROTO-5-UPDOWN: Line protocol on Interface Virtual-Access2, changed state to down I also enabled debug to see dhcp requests and nothing on the router:
0 kommentar(er)
